Procedures
............................................................................................................................................................................................................................................................
Create IP route
Purpose
Use this procedure to configure the IP Routing.
........................................................................................................................................................................................................................
Select Xcom -> Network Domain -> IP Route option from the menu bar.
1
........................................................................................................................................................................................................................
2
Clicking on Create hyperlink, the IP Routing window appears:
Figure 5-55 IP routing creation Page
........................................................................................................................................................................................................................
3
Table 5-17
parameters:
Table 5-17 IP routing parameters
Parameter
Access Identifier
............................................................................................................................................................................................................................................................
5 - 84
"IP routing parameters"
Description
Access Identifier, it specifies the STSn facility carrying the DCC
with the next hop network interface or identifies the IP Tunnel or
Customer LAN. The select hyperlink allows to open the window
shown in
the previous page." (p. 5-85)
After the selection procedure, the chosen value will be reported.
provides the description of IP Routing panel
"Click Cancel to revoke all the settings and return to
for the selection of the resource.
Create IP route
8DG08136EAAA
Issue 3 July 2009