Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 255

Tree area
............................................................................................................................................................................................................................................................
– EFEC Enhanced FEC (11GxAR line AID only)
– RSFEC Reed-Solomon FEC (line and client AID)
– EFEC2 Enhanced FEC2 (OT2TDM line port AID only)
The Default value is: <Previously-existing value> EFEC initially set by the system for
line AID on 11GxAR or <Previously-existing value> RSFEC for client AID on
11GxAR, and line port on OT2TDM.
•
– ADD_DROP bidirectional mode with a bidirectional signal added and dropped
– ADD unidirectional mode with the signal added only
– DROP unidirectional mode with the signal dropped only
– REGEN regenerator mode with a thru connection.
– DROP_REGEN regenerator mode with a thru connection and also a dropped
The Default value is: <Previously-existing value> ADD_DROP by the system.
•
•
•
•
•
•
– Save: By clicking this hyperlink all the operation are applied and the user goes
– Restore: Allows to restore the previous settings.
– Cancel: By clicking this hyperlink all the operation are not considered and the user
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
Operational Mode: It allows to configure the operational mode of the line port
only of an OT. It can only be changed when the client port state is OOS-MA, UAS.
It can be set to REGEN when the client signal have been deleted (DLT-rr). This
parameter does not apply to the OT2TDM module. The allowable values are:
connection.
OTU Rate: It specifies the OTU2 rate (standard 10.709, overclocked 11.049Gb/s,
overclocked 11.096Gb/s). It is set on the client side only when the client signal is
OTM0.2 and on the line side only when the Operational Mode is set to REGEN
mode. The 10G FC rate of 11.27Gb/s (OTM11.27) is not supported in REGEN
mode due to the added propagation delay which will cause login failure on the
Fibre Channel. This parameter does not apply to the OT2TDM module. The
allowable values are: OTM10.709 or OTM11.049 or OTM11.096.
The Default value is: OTM10.709.
Alarm Severity Assignment Profile Name: It specifies the ASAP name, in
<userlabel> format. Clicking on the Select hyperlink it is possible to start the
selection procedure.
Threshold Crossing Alert Profile Name: It specifies the TCA name, in
<userlabel> format. Clicking on the Select hyperlink it is possible to start the
selection procedure.
Current Primary State: It specifies the primary secondary service state.
Primary State: By means of this combo-box it is possible to change the primary
service state.
Current Secondary State: It specifies the secondary service state.
The panel has the following hyperlinks:
back to the previous page.
goes back to the previous page.
Access a resource
4 - 7 7