Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 216

Tree area
............................................................................................................................................................................................................................................................
•
•
•
•
•
•
•
The panel has the following hyperlinks:
– Delete restarts the page without considering the previous actions.
– Save which applies the previous selections and restart with new selection
– Remove which causes the specified facility client/line to be placed in an out-of-
Section Trace
•
It allows to change the settings of the resource by means of the following parameters:
•
•
•
Loopback
•
It allows to change the settings of the resource by means of the following parameters:
•
•
•
............................................................................................................................................................................................................................................................
4 - 38
Trace message: The entry box allows to digit the outgoing section trace message,
enclosed in quotation marks. If no characters is entered, then the transmitted
section trace message in the J0 byte is 01 hexadecimal.
Alarm Severity Assignment Profile Name: The entry box allows to digit the
label of the ASAP that is used for the unit. Clicking on the Select hyperlink it is
possible to select a different profile.
Command Execution Mode: The combo-box allows to select the command
execution mode. The allowable choices are: FRCD = Forced or NORM = Normal.
Current Primary state: It specifies the primary state to which the facility is set.
Primary State: The combo-box allows to change the primary state to which the
unit is set. The allowable choices are: IS = In Service and OOS= Out Of Service.
Current Secondary state: It specifies the secondary state to which the facility is
set.
Secondary State: The combo-box allows to change the secondary state to which
the unit is set. The allowable choices are: SGEO = Supporting Entity Outage or TS
= Test.
service (OOSMA or OOS-AUMA) state for maintenance purposes.
Access Identifier: It specifies the identifier of the unit resource. It is also shown in
the tree.
Incoming Message Format: The combo-box allows to set the format in which to
display the incoming trace message. The allowable choices are: TEXT = text
format or HEX = hexadecimal format. The default value is TEXT.
The panel has the Retrieve Section Trace hyperlink by means of which it is
possible to retrieve the contents of the SONET Section Trace message, a 15
character ASCII message. This command may be used to retrieve the "incoming"
Section Trace, or the "outgoing" Section Trace message that is inserted into the
Section overhead on the outgoing signal.
Access Identifier: It specifies the identifier of the unit resource. It is also shown in
the tree.
Location: The combo-box allows to chose the location in which the loopback is
performed. The allowable choices are: NEND = Near End. The default value is
NEND.
Loopback Type: The combo-boxes allow to specify the type of loopback. The
allowable choices (according the resource type) are:
Access a resource
8DG08136EAAA
Issue 3 July 2009