Pm Report; Pm Init Register; Pm Mode - Alcatel-Lucent 1850 TSS-320 User Provisioning Manual

Tree area
............................................................................................................................................................................................................................................................
– FACILITY = loopback at the receive side (from the network) to the transmit side
– TERMINAL = loopback where the signal that is about to be transmitted is
The default value is FACILITY. The panel has the Operate loopback hyperlink by means
of which it is possible to establish a near-end facility or terminal loopback on the specified
resource facility. To execute it, the specified resource must have a Primary State of OOS-
AUMA or OOS-MA and not have an Secondary State of LPBK (i.e. it is not already in a
loopback).
Alarm
•
The Alarm panel contains the View hyperlink which allows to show all the actual alarm.
PM functional tab
The PM functional tab is made up of three sub-functional tabs:

PM Report

•

PM Init Register

•

PM Mode

•
The PM Report sub-functional tab
Figure 4-23 PM Report
It allows to retrieve the current and/or historical 15-minute and/or 1-day PM data
corresponding to the PM data collection register(s) selected for the specified facility. For
each monitored parameter, the current and/or up to thirty-two (32) 15-minute historical
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
(to the network) of the specified facility.
connected to the associated incoming receiver .
Access a resource
4 - 3 9