Procedures
............................................................................................................................................................................................................................................................
Create XC Overhead
Purpose
Use this procedure to create overhead channel cross-connection.
........................................................................................................................................................................................................................
Select XCom -> DCC -> XC Overhead from the menu bar as shown in
1
Figure 5-49 Overhead channel cross-connection
........................................................................................................................................................................................................................
Click Create to configure a new Overhead Channel Cross-Connection as shown in
2
Figure
Figure 5-50 Overhead channel cross-connection - enter channel
........................................................................................................................................................................................................................
Table 5-13
3
parameters:
Table 5-13 Enter channel parameters
Parameter
DCC CHNL
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
5-50.
"Enter channel parameters"
provides description of Enter Channel panel
Description
Specifies the reference of the DCC Channel.
The values are:
LINE
•
SECTION
•
Create XC Overhead
Figure
5-49.
5 - 7 5