Ddrp Area Panel - Alcatel-Lucent 1850 TSS-320 User Provisioning Manual

Procedures
............................................................................................................................................................................................................................................................
BRSCOUNT: It represents the total number of Border Routers (BR) reachable within
•
this DDRP area. This is initially zero, and is calculated in each SPF pass.
ASBRSCOUNT: It represents the total number of Autonomous System Border
•
Routers (ASBR) reachable within this DDRP area.
Table 5-5
Table 5-5 DDRP AREA Panel
Parameter
AID
SPF RUNS
BRSCOUNT
ASBRSCOUNT
OPAQUE LSA COUNT
OPAQUE LSA CHECKSUM
Cancel
E O
N D
........................................................................................................................................................
Configure DDRP DB
........................................................................................................................................................................................................................
Clicking on the DDRP DB functional tab, the following page appears.
1
............................................................................................................................................................................................................................................................
5 - 28
provides the description of DDRP Area Panel as shown in
S
F T E P S
Description
It specifies an access Identifier for an DDRP area. Format:
{0-255}-{0-255}-{0-255}-{0-255} or ALL.
It represents the number of times that the intra-area DDRP
routing table has been calculated using this area's link-state
database. Format: <INTEGER>.
It represents the total number of Border Routers (BR)
reachable within this DDRP area.This is initially zero, and is
calculated in each SPF pass. Format: <INTEGER>.
It represents the total number of Autonomous System Border
Routers (ASBR) reachable within this DDRP area. Format:
<INTEGER>.
It represents the number of DDRP LSAs with LS type-10
(Opaque LSA) in this area's Link State Database. Format:
<INTEGER>.
It retrieves the 32 bit sum of LS checksums of all DDRP
LSAs with LS type-10 in this area's Link State Database.
Format: <INTEGER>.
Exits the tab and will show the Control PLane Global
Parameter
Control Plane - Configure OSPF and DDRP
Figure 5-18.
Issue 3 July 2009
8DG08136EAAA