Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 247

Tree area
............................................................................................................................................................................................................................................................
•
•
•
•
•
•
– NORM Normal, the command is denied if the result of its execution is service-
– FRCD Forced, the command is completed even if the result of its execution is
•
•
•
•
The panel has the following hyperlinks:
– Cancel: By clicking this hyperlink all the operation are not considered and the user
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
Automatic In-Service Threshold: It allows to set how long an input signal must
be present on the facility without a failure condition before the system transitions
the facility into the In-Service state, in HH-MM format, where value HH indicates
the time duration in hours and value MM indicates the time duration in minutes.
The default value is 08-00.
This parameter sets also the value of AINSTH for the ODU2 entity.
This parameter applies to the client side only.
This parameter does not apply to the OT2TDM module.
Automatic In-Service Timer: It specifies the duration of an alarm-free signal, in
HH-MM format, where value HH indicates the time duration in hours and value
MM indicates the time duration in minutes.
Trace Message: Optical channel transmitted Trail Trace Identifier (TTI), Transmit
Source Access Point Identifier (TX_SAPI). This parameter determines the
Transmit TTI channel content of the Section Monitoring overhead of an OTUk
information structure or the Path Monitoring overhead of the OTUkP information
structure. The Trail Trace Identifier shall follow the format defined in ITU-T
G.709, Clause 15.2. A TX_SAPI of less than 15 characters is padded out to the
right to 15 unprintable characters (e.g., whose hex representation is 0x00). 15
ASCII characters, enclosed in quotation marks. The coded representation is the 7
bit hex representation as specified by the ITU-T Recommendation T.50 (09/92)
International Reference Alphabet.
Alarm Severity Assignment Profile Name: It specifies the ASAP name, in
<userlabel> format. Clicking on the Select hyperlink it is possible to start the
selection procedure.
Threshold Crossing Alert Profile Name: It specifies the TCA name, in
<userlabel> format. Clicking on the Select hyperlink it is possible to start the
selection procedure.
Command Execution Mode: By means of this combo-box it is possible to change
the Command Execution Mode. The allowable choices are:
affecting.
service affecting.
Current Primary State: It specifies the primary secondary service state. Possible
displayed values are previously described in 4.8.2.3.1 on page 288.
Primary State: By means of this combo-box it is possible to change the primary
service state.
Current Secondary State: It specifies the secondary service state. Possible
displayed values are previously described.
Secondary State: By means of this combo-box it is possible to change the
secondary service state.
goes back to the previous page.
Access a resource
4 - 6 9