Connection - Data - Create Xc - P2P - Alcatel-Lucent 1850 TSS-320 User Provisioning Manual

Menu bar
............................................................................................................................................................................................................................................................
– Using Generic STS Commands (RTRV-CRS) for a searching identified by the
– STS Type - The combo-box allows to select one of the items STS1, STS3C,
– Circuit Type - The combo-box allows to select one of the items "Cross-
Retrieve Command - Specifies the TL1 Command used for the searching procedure
•
set in the Search Type field.
STS Access Identifier - The entry box allows to select one of the available STSn. It is
•
displayed only if Using a Specific STS Type Commands or Using a Generic STS
Command are selected for Search Type.
The Select hyperlink opens a popup window, which allows to search available STSn
of the selected STS Type.
The Search link is to start the search operation to filter the results.
Data
Select Connection -> Data -> Create XC -> P2P as shown in
Figure 3-9 Connection - Data - Create XC - P2P
The xconnection tab displays the P2P data connection panel that contains the following
parameters:
Type - The field shows the type of connection BIDIR or UNIDIR.
•
From - The entry box allows to enter the first point of the connection.
•
Click Select button it is possible to select one of the source port.
To - The entry box allows to enter the second point of the connection.
•
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
generic type of the STSn. Its selection arranges the panel accordingly.
STS12C, STS48C, STS192C in order to chose the hierarchical level of the signal.
connection" or "Conference" in order to chose the type of connection. It is
displayed only if Using a Specific STS Type Commands is selected for Search
Type.
Connection menu
Figure 3-9
3 - 1 9