Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 293

Procedures
............................................................................................................................................................................................................................................................
IPIP Creation
Clicking on the Create after the IPIP selection in the combo-box, the following page
appears:
Figure 5-22 IP-IP Port Creation Page
The page contains the IP-IP PORT CREATION panel:
Access Identifier: The entry box allows to enter the Access Identifier of the control
•
channel termination port. Allowable input parameter value and format:
– IPIP-{10-300000} Virtual Link using IPover IP encapsulation
It can be an OCn facility (IF-OOB configuration through DCC channel), an external
access identifier (LAN, IPIP, GRE) in OF-OOB application or a virtual link (VAID)
associated to IF-OOB termination port. The latter are provided to support DDRP
logical interface. VAID is referenced to the physical port access on DCC channel.
IP Address: The entry boxes allow to enter the Internet Protocol address. If the port is
•
NUMBERED this parameter represents its local IP address. The type of this address
must be IPv4 type. Value range [1-99, 101-126,128-223] - [0-255] - [0-255] - [0-254].
Mask: it is the entry boxes of the IP Mask, it is the IP subnet mask of the route (in the
•
format [0-255] - [0-255] - [0-255] - [0-255]). Default value: 0-0-0-0.
Port Class: The combo-box allows the user to define the Control Plane port type for
•
control channel termination. The user can establish on which port type control channel
has to be terminated. Choosing INNI the port is on an intra-domain link that contained
entirely within the routing domain. Choosing ENNI the port is an inter-domain link or
intra-domain link: link which connects this routing domain with a neighboring routing
domain. Allowable values are:
– INNI, INTRA-ENNI and INTER-ENNI. Default value: INNI.
Mtu: (Maximum Transmit Unit) The entry box allows to adjust the size, in octets, for
•
packet transfer in control channel. Value range: {1-1500}. Default value: 1491.
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
Control Plane - Routing: Create Control Channel Interface
5 - 3 3