Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 304

Procedures
............................................................................................................................................................................................................................................................
– M# = {0 - 15} (Index of VT1.5-SPE/VC11 or VT2-SPE/VC12 or VT3-SPE within
Revertive Protection: The combo-box allows to select the Revertive protection for
•
path protected connection support. It applies at path protection switching, restoring or
not the primary path when it becomes available. This parameter is valid if path
protection is selected by user on Protection Type input. Possible values: YES or NO
(default).
Pinned mode supported: The combo-box allows to select the Connection pinned
•
mode support. It is applied on path restoration. If this parameter entered as YES, then,
upon connection restoration the new path will strictly follow the original connection
path. Possible values: YES or NO (default).
Include ALL: The entry box allows to digit the connection path including all affinity
•
(resource color) constrain. All the links matching this specified affinity value (32-bit
integer) are included in path computation for the network connection. Possible values:
{1 - 4294967295}.
Include ANY: The entry box allows to digit the connection path includes any affinity
•
(resource color) constrain. Any of the links matching this specified affinity value (32-
bit integer) are included in path computation for the network connection. Possible
values: {1 - 4294967295}.
Exclude ANY: The entry box allows to digit the Connection path excludes any affinity
•
(resource color) constrain. Any of the links matching this specified affinity value (32-
bit integer) are excluded in path computation for the network connection. Possible
values: {1 - 4294967295}.
Admin State: The combo-box allows to select the Connection administrative status,
•
set by management. Possible values:
– ON: Connection is committed.
– OFF: Connection is provisioned but not committed.
Traffic Identifier: The entry box allows to define bandwidth profile for the end-to-
•
end connection, referred to the LSP tunnel. For E-NNI connection, only TD-ID with
switching capability = TDM or DWDM are supported, for Packet connection only
PSC is supported. Command is rejected if matching TD could not be found. Clicking
on the select hyperlink, starts the selection procedure. After the selection procedure,
the chosen value will be reported.
Hoplist ID: The entry box allows to define Hoplist Identifier assigned by user in the
•
Control Plane for the end-to-end connection. It defines a sequence of "next-hops" in
the connection set-up, using ERO Object RSVP signaling. If this parameter is not
specified, path is retrieved from CSPF database. Clicking on the select hyperlink,
starts the selection procedure. After the selection procedure, the chosen value will be
reported.
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
5 - 44
a VTGroup/TUG-2 signal)
S
F T E P S
Control Plane - Signalling: Create Network Connection
8DG08136EAAA
Issue 3 July 2009