Create Aps; Aps Configuration Panel Parameters - Alcatel-Lucent 1850 TSS-320 User Provisioning Manual

Procedures
............................................................................................................................................................................................................................................................

Create APS

Purpose
This procedure allows the operator to create a 1+1 Linear APS (Automatic Protection
System defined in GR-253-CORE) where the OC-n ports must be configured on an
adjacent pair of cards, with the Protected/West port in the lower numbered slot and
Protecting/East port in the next higher numbered slot. For optical modules that support
multiple ports, the port numbers specified must be same for both the working and the
protection entities.
In this release, Linear 1+1 APS operates in UNIdirectional mode with no automatic
reversion.
........................................................................................................................................................................................................................
Select Protection -> APS options in the Menu bar.
1
........................................................................................................................................................................................................................
Clicking on Create hyperlink APS Configuration Panel appears:
2
Figure 5-60 APS creation
........................................................................................................................................................................................................................
3 Table 5-21
Configuration Panel Parameters.
Table 5-21 APS Configuration Panel Parameters
Parameter
FFP Access Identifier
Protected Access Identifier
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009

"APS Configuration Panel Parameters"

provides the description of APS
Description
It is referenced to the protected entity in the FFP (Fast
Facility Protection) group. The protecting entity is
automatically taken as the same port on the next adjacent
module.
It is the Access Identifier of the West/Working/Preferred
member of the FFP. The Select hyperlink allows to start
the selection process. After the selection procedure, the
chosen value will be reported.
Create APS
5 - 9 1