Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 294

Procedures
............................................................................................................................................................................................................................................................
Encaps Remote Address: The entry boxes allow to set the parameter that is used to
•
enter the IP address of the remote end of the control channel termination port. Value
range {1-99, 101-126,128-223} - {0-255} - {0-255} - {1-254}.
Encaps Remote Id: The entry boxes allow to set the parameter that is used to enter the
•
IP address of the remote end of the control channel termination node. Value range: {1-
99, 101-126,128-223} - {0-255} - {0-255} - {1-254}.
Status: The combo-box allows the user to choose the state of the Control channel port
•
administrative status. Allowable values are:
– ON Control channel is enabled by management
– OFF Control channel is disabled by management
The page has the following hyperlinks:
– Cancel: By clicking this hyperlink you go back to the Control Channel Interface
– Save: By clicking this hyperlink the user apply the changes and turn back to the
E O
N D
........................................................................................................................................................
GRE Creation
Clicking on the Create after the GRE selection in the combo-box, the following page
appears:
Figure 5-23 GRE Port Creation Page
The page contains the GRE PORT CREATION panel which has the same fields described
in the IPIP creation section.
TE- Link Creation
Clicking on the Create after the TE-Link selection in the combo-box, the following page
appears:
............................................................................................................................................................................................................................................................
5 - 34
Creation panel.
previous page.
S
F T E P S
Control Plane - Routing: Create Control Channel Interface
8DG08136EAAA
Issue 3 July 2009