Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 364

Procedures
............................................................................................................................................................................................................................................................
Parameter
Revert delay time (min)
Preferred 2
Switch on UNEQ-P 2
Revert 2
Revert delay time 2 [min]
Save
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
5 - 10 4
S
F T E P S
Description
It indicates the revert delay time (when the next column
refers Y) in minutes. The possible values are in the 0 to 15
minutes range.
It indicates the preferred direction for a cross-connect
selector function for the dual interconnected ring (ring 2)
with UPSR non-pass-through cross-connections.
It indicates whether or not to switch when an UNEQ-P
condition occurs on ring 2. This parameter is only
applicable to non-pass-through cross-connections in
UPSR. The possible values are: N (do not switch on
UNEQ-P) or Y (switch on UNEQ-P).
It indicates whether or not to make revert mode automatic
on the dual interconnected ring (ring 2). This parameter is
only applicable to non-pass-through cross-connections in
UPSR. The possible values are: N (do not revert to
working/preferred) or Y (revert to working/preferred).
It indicates the revert delay time for ring 2 (when the next
column refers Y) in minutes. The possible values are in
the 0 to 15 minutes range.
Allows the User to save the settings.
Provision STS Cross Connection
8DG08136EAAA
Issue 3 July 2009