Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 253

Tree area
............................................................................................................................................................................................................................................................
Figure 4-41 PM Baseline tab for DWDM module (e.g. XFP)
The PM Baseline functional tab has the Set Baseline and Retrieve Baseline panels
which allow to set the parameters for the PM collection. They contain the following
parameters:
•
•
•
The panels have the following hyperlinks:
– Cancel: By clicking this hyperlink the user leave the page.
– Save: By clicking this hyperlink the user saves the settings.
– Retrieve: By clicking this hyperlink the user starts the PM data baseline.
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
Access Identifier: It identifies the entity access identifier in the <OTPORT>-
<rack>-<shelf>-<slot>-<side> format. It is also shown in the tree.
Monitored parameter type: It specifies the monitored type which will be
baselined. The allowable values are: ALL (All Supported Parameters Baselined) or
OPR (Optical Power Received Baselined) or OPT (Optical Power Transmitted
Baselined). The Default value is ALL.
Reason: It defines the reason for baselining. The allowable values are: LOS_CLR
(Loss of Signal defect has been cleared) or NEW_SYSTEM (Indicates that the
reason for baselining is installation of a new system) or OT_REPLACED (OT
pack is being replaced) or 0 - 9 (User configurable code for baselining reason).
Access a resource
4 - 7 5