Procedures
............................................................................................................................................................................................................................................................
Figure 5-28 Network Creation Page
The Create Conn panel contains:
Call identifier: The entry box allows to digit the Connection Identifier as connection
•
name assigned by user in the Control Plane. Connection Identifier has to be unique in
the system.
Replace (using make-before-break technique): The entry box allows to digit the
•
present connection replacement using make-before-break technique.
Direction: The combo-box allows to select the CALL connection direction
•
(unidirectional/bidirectional). Possible values:
– UNIDIR unidirectional
– BIDIR bidirectional
Protection Type: The combo-box allows to select the Connection path protection type
•
assigned by user in the Control Plane. Its significance is related to Layer parameter.
Possible values:
– NO (unprotected)
– PATH-ONE-TO-ONE For future release
– PATH-ONE-PLUS-ONE For TDM layer
– PATH-REROUTE For future release
– LINK-ONE-TO-ONE For future release
– LINK-ONE-PLUS-ONE For TDM layer
............................................................................................................................................................................................................................................................
5 - 42
Control Plane - Signalling: Create Network Connection
8DG08136EAAA
Issue 3 July 2009