Alcatel-Lucent 1850 TSS-320 User Provisioning Manual page 259

Tree area
............................................................................................................................................................................................................................................................
•
The Default value is: <Previously-existing value> initially set by the system based on the
client signal. If no client signal is provisioned then the NULL (FD hex) value is used.
•
•
•
•
•
The panel has the following hyperlinks:
– Save: By clicking this hyperlink the user saves the settings.
– Remove: By clicking this hyperlink the user logically remove the settings.
– Cancel: By clicking this hyperlink the user leave the page.
2. Trail Trace Info panel
The fields of this panel are previously described in 2), but addressed to this facility.
3. OTU2 LINE functional tab
Clicking on the OTU2 LINE functional tab the page depicted in previous section is
shown, but addressed to this facility.
4. OTU2 PM LINE functional tab
Clicking on the OTU2 PM LINE functional tab the page depicted in previous section
is shown, but addressed to this facility.
............................................................................................................................................................................................................................................................
8DG08136EAAA
Issue 3 July 2009
Payload Type: It is the Payload Type (PT) field content of a Payload Structure
Identifier (PSI) of the OTUk structure. It has a default value and is based on the
encoded client signal. It only apply when OPRMODE (ED-OTU2) is non REGEN
mode and when the client signal is not an OTM0.2 signal. In order to facilitate
interworking with non compliant PT values. It shall be possible to provision the
payload type to a different value in a 2 digits hex format. This parameter does not
apply to the OT2TDM module. The allowable values are 2 digits hex format.
Alarm Severity Assignment Profile Name: It specifies the ASAP name, in
<userlabel> format. Clicking on the Select hyperlink it is possible to start the
selection procedure.
Threshold Crossing Alert Profile Name: It specifies the TCA name, in
<userlabel> format. Clicking on the Select hyperlink it is possible to start the
selection procedure.
Current Primary State: It specifies the primary secondary service state.
Primary State: By means of this combo-box it is possible to change the primary
service state previously described.
Current Secondary State: It specifies the secondary service state.
Access a resource
4 - 8 1