Cmm Front Panel - Alcatel-Lucent OmniSwitch 9800E Hardware User's Manual

Chassis Management Module (CMM)

CMM Front Panel

Module Status LEDs
OK1.
Hardware Status. Displays solid green
when powered on and the CMM has passed
hardware diagnostic tests. Displays solid amber
when powered on and the CMM has failed hard-
ware diagnostic tests.
OK2. Software Status. Blinks green when the
CMM is operational. Displays solid amber when
a system software failure occurs. Blinks amber
when the software is in a transitional state (e.g.,
when software is being downloaded to the
switch).
Control/Fabrics/PSU/Temperature/Fan sta-
tus LEDs
CONTROL. Displays solid green when the
CMM is active, blinking green when standby,
amber when malfunctioning, and blinking
amber for upgrade.
FABRIC. Displays solid green when the fabric
is active, blinking amber or steady amber for
different fabric malfunctions.
TEMP. Displays green at 0-40°C, blinking
amber at 40-45°C, and solid amber at over 45°C.
FAN. Displays solid green when all fans in the
fan tray are running at normal speed. Displays
solid amber if a fan error occurs (i.e., one or
more fans are not running at normal speed).
PSU. Displays green when power is OK, blink-
ing amber when one PSU is bad but the chassis
has enough power, and solid amber when the
chassis does not have enough power.
Ethernet Management Port LEDs
LINK. Link/Activity Status. Displays solid
green when an Ethernet cable connection exists
at the CMM's Ethernet Management Port.
Flashes green as data is transmitted or received.
OmniSwitch 9000E Series Hardware Users Guide
Module
Status
LEDs
CMM Front Panel (OS9700E-CMM version shown)
December 2008
CMM Front Panel
USB Port. High speed (480 Mbps) USB
2.0 port, which can be used for quick
upgrades.
Note:
USB port is not supported in this
release.
Console Port. The CMM's front panel
provides one RJ-45 port for console
connections. By default, this connector
provides a DCE console connection.
Ethernet Management Port (EMP).
The CMM's front panel also provides
one Ethernet 10/100/1000BaseT port
(copper RJ-45). This port provides out-
of-band network management and can
be used for Telnet sessions, switch diag-
nostics, and for downloading software
to the switch.
This 10/100/1000BaseT port supports
both 10BaseT,100BaseT and
1000BaseT with auto-negotiation
through the RJ-45 connector.
Note: In redundant CMM configura-
tions, the EMP is only operational on
the primary CMM.
page 3-3