Table of Contents
Advertisement
Common Configuration Tasks
Configuring MPLS Components
Use the MPLS and RSVP CLI syntax displayed below for:
Configuring Global MPLS Parameters
Admin groups can signify link colors, such as red, yellow, or green. MPLS interfaces
advertise the link colors it supports. CSPF uses the information when paths are computed for
constrained-based LSPs. CSPF must be enabled in order for admin groups to be relevant.
To configure MPLS admin-group parameters, enter the following commands:
CLI Syntax: mpls
The following displays an admin group configuration example:
A:ALA-1>config>router>mpls# info
----------------------------------------------
...
----------------------------------------------
A:ALA-1>config>router>mpls#
Page 122
•
Configuring Global MPLS Parameters on page 122
•
Configuring an MPLS Interface on page 123
•
Configuring MPLS Paths on page 124
•
Configuring an MPLS LSP on page 125
•
Configuring a Static LSP on page 126
•
Configuring Manual Bypass Tunnels on page 127
•
Configuring RSVP Parameters on page 129
•
Configuring RSVP Message Pacing Parameters on page 130
•
Configuring Graceful Shutdown on page 131
admin-group group-name group-value
frr-object
resignal-timer minutes
resignal-timer 500
admin-group "green" 15
admin-group "yellow" 20
admin-group "red" 25
7950 SR OS MPLS Configuration Guide
Advertisement
Chapters
Table of Contents
