Error Code Fip; Level 1 Fip; Fip1.1 Nvm Error - Oki B6200 Maintenance Manual

4. Error Code FIP

4.1 Level 1 FIP

FIP1.1 NVM Error

Step
Possible causative parts:
HVPS/MCU (PL12.1.19)
1 Does Error occur when the power is turned ON?
Does Error still occur when the power is turned OFF and
2
ON again?
Does Error still occur after several ON/OFF procedures of
3
the power?
Checking HVPS/MCU non-volatile memory setup mode
4 Is non-volatile memory setup mode accessible?
Checks by Chapter 2 Diagnostic [DC301 NVM Initialize].
Checking NVRAN for data setup
Are all NVRAM data set appropriately?
5
Checks by Chapter 2 Diagnostic [DC131 NVM Read/
Write].
Checking Error after changing HVPS/MCU data setup
6 Change NV RAM data to the correct setup value, and then
turn the power ON again. Does Error still occur?
Checking after replacing HVPS/MCU
7
Does Error occur?
*1: Though some kind of foreign noise would be possible cause, go to [FIP2.19 Electrical Noise] and
check, to make sure.
Check
1 - 22
Chapter 1 Troubleshooting
Yes
Go to step 4.
Go to step 4.
Go to step 4. End of work *1
Go to step 5.
Go to step 7.
Replace
HVPS/MCU,
then go to step 7.
(RRP12.10)
Go to FIP2.19
Electrical Noise.
No
Go to step 2.
Go to step 3.
Replace
HVPS/MCU.
(RRP12.10)
Go to step 6.
End of work
End of work