Oki B6200 Maintenance Manual page 435

Removal
1) Remove the COVER REAR 250 (PL9.1.12). (RRP9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14). (RRP9.7)
5) Remove the CHUTE LW EXT2 ASSY (PL9.1.2). (RRP9.1)
6) Release the hook of the GEAR 21 (PL9.1.20), and remove it from the ROLL EXIT.
7) Release the hook of the BEARING EXIT (PL9.1.18) on the GEAR 21 side, and lift up the ROLL
EXIT, then, remove the BEARING EXIT from the ROLL EXIT.
Be careful handling the hook of the BEARING EXIT. It is fragile and could break if
given excessive force.
8) Remove the ROLL EXIT from the other side of the BEARING EXIT by shifting the ROLL EXIT in
the direction of the arrow as shown in the figure.
When removing, do not hold the rubber rollers of the ROLL EXIT.
Replacement
1) Install the ROLL EXIT to the BEARING EXIT (PL9.1.18) by shifting the ROLL EXIT in the opposite
direction of the arrow.
When installing, do not hold the rubber rollers of the ROLL EXIT.
2) Put the BEARING EXIT to the ROLL EXIT on the GEAR 21 side, and install the BEARING EXIT to
the CHUTE UPPER EXIT (PL9.1.15), then, secure it with the hook.
3) Install the GEAR 21 (PL9.1.20) to the ROLL EXIT, and secure it with the hook.
4) Install the CHUTE LW EXT2 ASSY (PL9.1.2). (RRP9.1)
5) Install the CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14). (RRP9.7)
6) Install the COVER LEFT (PL1.1.6). (RRP1.3)
7) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
8) Install the COVER REAR 250 (PL9.1.12). (RRP9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 271