Removal
1)
Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2)
Remove the 3 screws (silver with flange, 8mm x 2, gold tapping, 8mm x 1) securing the COVER
REAR to the printer.
3)
Open the COVER REAR in the direction of the arrow. Release the 3 hooks securing the COVER
REAR to the printer, and remove it from the printer.
Replacement
1)
Insert the 3 hooks on the left side of the COVER REAR into the 3 holes of the printer.
2)
Secure the COVER REAR to the printer using the 3 screws (silver with flange, 8mm x 2, gold tap-
ping, 8mm x 1).
There are 2 kinds of screws, make sure they are put in the right place.
When tightening the screws be careful not to pinch the harness between the boad
and frame.
3)
Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 8