Oki B6200 Maintenance Manual page 366

24PPM
Removal
1) Remove the COVER REAR 250 (PL9.1.12). (RRP9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
5) Remove the CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14). (RRP9.7)
6) Remove the CHUTE LW EXT2 ASSY (PL9.1.2). (RRP9.1)
7) Remove the COVER TOP (PL1.1.7). (RRP1.4)
8) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
9) Remove the DUCT FRONT (PL8.1.4). (RRP8.2)
10) Release the 2 clampers holding the harnesses, from the PLATE TIE FRONT (PL12.1.2).
11) Remove the 8 screws (silver, 6mm) securing the PLATE TIE FRONT to the frame, and remove the
PLATE TIE FRONT.
12) Release the 2 clampers holding the harnesses, from the ROS ASSY.
13) Disconnect 3 connectors of the HARNESS ROS ASSY with gray-colored wire from the printed cir-
cuit board on the ROS ASSY. The connector with yellow-colored wire remains connected.
The printed circuit board on the ROS ASSY is fragile, therefore, be sure to hold it
with hand when disconnecting the connectors.
14) Remove the 5 screws (black with flange, 8mm) securing the ROS ASSY to the frame.
Never give any impact to the ROS ASSY with a screwdriver or other tools.
15) Remove the ROS ASSY.
Replacement
1) Install the ROS ASSY to the frame using the 5 screws (black with flange, 8mm).
Never give any impact to the ROS ASSY with a screwdriver or other tools.
2) Connect 3 connectors of the HARNESS ASSY ROS to the printed circuit board on the ROS ASSY.
The printed circuit board on the ROS ASSY is fragile, therefore, be sure to hold it
with hand when connecting the connectors.
3) Secure the harness with the 2 cable clampers on the ROS ASSY.
4) Install the PLATE TIE FRONT (PL12.1.2) to the frame using the 8 screws (silver, 6mm) and tighten
firmly.
Be sure to perform this operation on a level and smooth worktop.
5) Secure the harness to the PLATE TIE FRONT using the 2 clampers.
6) Install the DUCT FRONT (PL8.1.4). (RRP8.2)
7) Install the COVER FRONT (PL1.1.5). (RRP1.5)
8) Install the COVER TOP (PL1.1.7). (RRP1.4)
9) Install the CHUTE LW EXT2 ASSY (PL9.1.2). (RRP9.1)
10) Install the CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14). (RRP9.7)
11) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 202