How To Select Diag Code - Oki B6200 Maintenance Manual

1.6 How to Select Diag Code

1. Enter the Diag (C/E) mode.
2. Select an applicable menu item in the common menu using the " ↑ " or " ↓ " key.
3. To select a Diag Code (DC) item in a lower level, use the " → " key.
4. To select a DC item in the same hierarchical level, use the " ↑ " or " ↓ " key.
5. Press the "FEED / SELECT" key to fix a desired DC item.
6. Press the "FEED / SELECT" key again to execute the process.
No key operation can be executed during executing the process.
7. When the process has been completed, "*" is marked at the right-hand side of the DC menu and the
key operation becomes available.
8. Show the screen to prompt you to exit the Diag mode, , using the " ← " or "MENU" key.
9. Press the "MENU" key to return to any common menu which belongs to an upper level.
<Example of Operation of [DC301 NVM Init. (area: IOT)]>
Diag. Menu
Preventive Diag
Diag. Menu
Fault Diag.
Diag. Menu
Adjustment
In [DC301 NVM Init.], only [area:SYS] can be executed. [area:IOT] and [area:ALL]
cannot be executed ("Parameter NG" is shown).
Button
Adjustment
DC131 NVM R/W
Adjustment
DC301 NVM Init.
2 - 5
Chapter 2 Operation of Diagnostic
Button
MENU
SELECT
Diag. Menu
Adjustment
MENU
NVM Initialized
Please Exit Diag
DC301 NVM Init.
SYS
Initial Display
MENU Key
FEED/SELECT Key
DC301 NVM Init.
Area SYS*
SELECT
DC301 NVM Init.
Area SYS
SELECT
Area
IOT
Area
ALL
Area
SYS