Dc355 Hdd Diag - Oki B6200 Maintenance Manual

DC355 HDD DIAG

Description: Performs setups, change judgments, etc. when changing or checking HDD.
• HDD read verification test can be performed.
• HDD partition size can be checked.
• HDD partition size can be set.
• HDD (file system) can be set up.
• HDD fault diagnosis can be performed.
• SMART (Self-monitoring, analysis and reporting technology) of HDD can be executed to predict
HDD failure.
• Any operation cannot be interrupted.
• If any failure unrelated to an operation occurs, the operation can be continued.
• Any setting made in the [Partition setting] screen is enabled after M/C is rebooted
using the Diag Exit screen.
• If M/C is rebooted after making settings in the [Partition setting] screen, rebooting
is performed automatically again during M/C initialization.
• Any operation to activate HDD cannot be executed before exiting the Diag mode
after [Partition setting]. However, the following operations can be executed:
(1) Checking a partition size
(2) Setting a partition size
• If you make settings in the [Partition setting] screen several times, the last setting
is enabled.
<Executing a read verification test>
"It takes a long time (approximately 20 minutes for 4GB) to execute a read
verification test ("Read Verify Test"). So, if an error code which seems to be related
to HDD is shown (including any error which disappears when HDD is removed), it is
practical to execute a fault diagnosis and prediction and to set (= format) a partition
size ("Partition setting") before changing HDD.
Procedure:
1. Enter the Diag (C/E) mode, and select [Diag. Menu Fault Diag.] in the same hierarchical level using
the " ↓ " key.
2. Select the [Fault Diag. DC140 Monitor] screen in a lower level using the " → " key.
3. Select [Fault Diag. DC355 HDD DIAG] in the same hierarchical level using the " ↓ " key.
4. Select the [DC355 HDD DIAG Read Verify Test] screen using the " → " key.
5. Show the setting item screen using the " → " key again. Then, to perform read verification tests of
all partitions, follow the step below. To perform a read verification test of each partition individually,
go to the step 6.
(1) Select [Read Verify Test If OK press SEL] in the same hierarchical level using the " ↓ " key.
Read Verify Test
Partition ALL
2 - 21
Chapter 2 Operation of Diagnostic