Oki B6200 Maintenance Manual page 370

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.5)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
5) Remove the COVER EXIT 500 (PL10.1.1)/CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14).
(RRP10.1/9.7)
6) Remove the 500 EXIT ASSY (PL10.1.2)/CHUTE LW EXT2 ASSY (PL9.1.2). (RRP10.2/9.1)
7) Remove the COVER TOP (PL1.1.7). (RRP1.4)
8) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
9) Disconnect the connector (P/J270) of the FAN SUB from the HARNESS ASSY LVPS (PL12.1.1).
10) Remove the 3 screws (silver tapping with flange, 8mm x1, gold tapping, 8mm x 2) securing the
DUCT FRONT.
11) Remove the DUCT FRONT attached with the FAN SUB from the frame by moving it in the direction
of the arrow.
12) Release the hook securing the FAN SUB to the DUCT FRONT, and remove the FAN SUB.
Replacement
1) Install the FAN SUB to the DUCT FRONT, and secure it with the hook.
When installing the FAN SUB to the DUCT FRONT, be sure to install the FAN SUB
so that the label is facing inside and the harness is in the place shown in the figure.
2) Install the DUCT FRONT attached with the FAN SUB to the frame by moving the opposite direction
of the arrow shown in the figure.
3) Install the DUCT FRONT to the frame using the 3 screws (silver tapping with flange, 8mm x1, gold
tapping, 8mm x 2).
4) Connect the connector (P/J270) of the FAN SUB to the HARNESS ASSY LVPS (PL12.1.1).
5) Install the COVER FRONT (PL1.1.5). (RRP1.5)
6) Install the COVER TOP (PL1.1.7). (RRP1.4)
7) Install the 500 EXIT ASSY (PL10.1.2)/CHUTE LW EXT2 ASSY (PL9.1.2). (RRP10.2/9.1)
8) Install the COVER EXIT 500 (PL10.1.1)/CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14).
(RRP10.1/9.7)
9) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
10) Install the COVER LEFT (PL1.1.6). (RRP1.3)
11) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
12) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.5)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 206