Oki B6200 Maintenance Manual page 31

Chain Link Fault Items
103 208 All Serial No. Mismatch
103 320 SEEPROM Fail
103 321 Backup SRAM Fail
ESS ROM DIMM #1 Not
103 331
Found
103 332 ESS Standard ROM Error
103 333 ASIC Fail
103 334 Standard Font ROM Error
103 335 Font ROM Not Found
103 337 ESS Standard RAM Error
103 338 Same Font ROMs Found
ROM DIMM of Another
103 339
Product Found
103 372 IOT sc S/W Fail
IOT Manager software
103 373
error
IOT IM DeviceDriver
103 374
software error
116 200 Main PWB IC Fail
116 201 HD Fail
M/C is not started
because a ProductCode
116 203
trouble is caused to HDD
when starting.
M/C is not started
because incorrect
116 204 capacity of HDD is
detected when formatting
HDD.
Conditions of detect/Methods of treatment
At least one of Serial No. which are maintained in three points become
wrong value.
Execute DC132 Serial No matching.
When it is not recovered yet, Replace ESS PWB or MCU PWB in
order. (Replacing both of them simultaneously is impossible.)
Writing to SEEPROM on ESS PWB is not available.
When it is not recovered by powering OFF and On, replace ESS PWB.
Writing to SRAM on ESS PWB is not available.
When it is not recovered by powering OFF and On, replace ESS PWB.
Extension ROM is not installed. (Option)
Install extension ROM.
If the trouble is not recovered by installing it, Replace ESS PWB.
Detect standard ROM(On board) error.
When it is not recovered by powering OFF and On, replace ESS PWB.
Internal process error is caused within ESS PWB.
When it is not recovered by powering OFF and On, replace ESS PWB.
Detect the trouble of ESS standard built in fonts ROM.
When it is not recovered by powering OFF and On, replace ESS PWB.
Font ROM is not built in.
If only the standard font ROM is built in, Replace ESS PWB.
If the option font ROM is installed, insert and remove theoption font
ROM.
When it is not recovered yet, replace the option font ROM.
Detect the error of ESS standard built in RAM.
When it is not recovered by powering OFF and On, replace ESS PWB.
Detect that the same font ROM is installed.
Check the font ROM.
If the trouble is not recovered, execute the followings.
Replace ESS PWB.
Detect that the ROM for other machine is installed.
An error is caused when processing the software in ESS PWB, and the
process cannot be continued after that.
Replace ESS PWB.
An error is caused when processing the software in ESS PWB, and the
process cannot be continued after that.
Replace ESS PWB.
An error is caused when processing the software in ESS PWB, and the
process cannot be continued after that.
Replace ESS PWB.
The trouble is caused to IC in ESS PWB.
When it is not recovered by powering OFF and On, replace ESS PWB.
HDD is not started because a physical trouble is caused to HDD when
starting.
When it is not recovered by powering OFF and On, execute the
follownings.
Execute HDD Test (DC355)
Replace HDD
Replace ESS PWB
HDD is not started because a ProductCode trouble is caused to HDD
when starting.
The possibility that it is formatted by wring product M/C is high.
Format HDD again.
Replace HDD.
HDD is formatted, but the incorrect HDD is connected or a trouble of
HDD is caused.
Format HDD again.
Replace HDD.
1 - 15
Chapter 1 Troubleshooting
Ref FIP