Oki B6200 Maintenance Manual page 395

34PPM
Removal
1) Remove the COVER REAR 500 (PL10.2.21). (RRP10.9)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
4) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
5) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
6) Remove the COVER EXIT 500 (PL10.1.1). (RRP10.1)
7) Remove the 500 EXIT ASSY (PL10.1.2). (RRP10.2)
8) Remove the COVER TOP (PL1.1.7). (RRP1.4)
9) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
10) Remove the BTR ASSY (PL8.1.21). (RRP8.10)
11) Remove the DUCT FRONT (PL8.1.4). (RRP8.2)
12) Remove the ROS ASSY (PL8.1.1). (RRP8.1)
Never give any impact to the ROS ASSY with a screwdriver or other tools.
13) Remove the SHIELD PLATE ROS (PL8.1.3). (RRP8.3)
14) Remolve the GUIDE TRAY LEFT (PL7.1.7). (RRP7.8)
15) Remove the MOTOR COVER (PL11.1.1). (RRP11.1)
16) Remove the SHIELD PLATE LVPS (PL12.1.3). (RRP12.1)
17) Remove the GUIDE CRU LEFT (PL8.1.15). (RRP8.4)
18) Release the hooks securing the COVER GUIDE CRU (PL8.1.16) to the GUIDE CRU LEFT, and
remove the COVER GUIDE CRU together with the HARNESS ASSY FUSER.
Be careful handling the hooks of the GUIDE CRU LEFT. They are fragile and could
break if widen them to much.
Replacement
1) Install the COVER GUIDE CRU (PL8.1.16) together with the HARNESS ASSY FUSER to the
GUIDE CRU LEFT (PL18.1.15).
2) Install the GUIDE CRU LEFT (PL8.1.15). (RRP8.4)
When installing, make sure that the LEVER LINK (PL8.1.29) is attached to the
GUIDE CRU LEFT.
After installing the GUIDE CRU LEFT, touch the LINK GEAR 3 with your finger.
Make sure that your finger can feel the LINK GEAR 3 move inward, when the LEVER
LINK is pulled up.
3) nstall the SHIELD PLATE LVPS (PL12.1.3). (RRP12.1)
4) Install the MOTOR COVER (PL11.1.1). (RRP11.1)
5) Install the GUIDE TRAY LEFT (PL7.1.7). (RRP7.8)
6) Install the SHIELD PLATE ROS (PL8.1.3). (RRP8.3)
7) Install the ROS ASSY (PL8.1.1). (RRP8.1)
Never give any impact to the ROS ASSY with a screwdriver or other tools.
8) Install the DUCT FRONT (PL8.1.4). (RRP8.2)
9) Install the COVER FRONT (PL1.1.5). (RRP1.5)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 231