Oki B6200 Maintenance Manual page 524

Removal
1) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
2) Remove the SHIELD ASSY ESS (PL12.1.14). (RRP12.7)
3) Remove the SHIELD PLATE HVPS (PL12.1.18). (RRP12.9)
4) Remove the screw (silver, 6mm) securing the BRACKET HANDLE R (PL12.1.12) to the frame.
5) Remove the BRACKET HANDLE R from thr frame.
6) Disconnect the harness connectors from the connectors (P/J10, P/J11, P/J13, P/J14, P/J15, P/
J16, P/J17, P/J18, P/J20, P/J22, P/J24, P/J26, P/J 27, P/J 28, P/J29, P/J30, and P/J31) on the
HVPS/MCU.
7) Remove the 3 screws (silver, 6mm) securing the BRACKET SHIELD HVPS (PL12.1.25) to the
frame.
8) Remove the BRACKET SHIELD HVPS.
9) Remove the 4 screws (silver, 6mm) securing the HVPS/MCU to the frame.
10) Remove the HVPS/MCU.
Replacement
1) Install the HVPS/MCU to the frame using the 4 screws (silver, 6mm).
When installing the HVPS/MCU, install the board under the hook of the frame.
(NOTE 1)
When tightening the screws, be careful not to pinch the harness between the board
and frame. (NOTE 2)
2) Connect the connectors of the harness to the connectors (P/J10, P/J11, P/J13, P/J14, P/J15, P/
J16, P/J17, P/J18, P/J20, P/J22, P/J24, P/J26, P/J 27, P/J 28, P/J29, P/J30, and P/J31) on the
HVPS/MCU.
3) Install the BRACKET SHIELD HVPS (PL12.1.25) to the frame using the 3 screws (silver, 6mm).
4) Install the BRACKET HANDLE R (PL12.1.12) to the frame using the screw (silver, 6mm).
5) Install the SHIELD PLATE HVPS (PL12.1.18). (RRP12.9)
6) Install the SHIELD ASSY ESS (PL12.1.14). (RRP12.7)
7) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 360