Removal
1)
Remove the COVER REAR 250 (PL9.1.12). (RRP9.4)
2)
Remove the COVER REAR (PL1.1.3). (RRP1.1)
3)
Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
4)
Remove the FAN MAIN (PL12.1.10). (RRP12.6)
5)
Remove the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
6)
Remove the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
7)
Disconnect the connector (P/J248) of the HARNESS ASSY TRAY 2 (PL6.1.36) from the HAR-
NESS ASSY CHUTE (PL12.1.17).
8)
Release the holdings of the harness from 2 clampers on the PLATE TIE (PL6.1.35).
9)
Remove the 4 screws (silver, 6mm) securing the PLATE TIE to the frame.
10) Remove the 2 screws (silver with flange, 8mm) securing the CHUTE OUT (PL6.1.33) to the frame.
11) Remove the 250 FEEDER ASSY from the frame.
Replacement
1)
Install the 250 FEEDER ASSY.
2)
Secure the CHUTE OUT (PL6.1.33) to the frame using the 2 screws (silver with flange, 8mm).
One of the screws that secure the CHUTE OUT to the frame is tightened together
with the SPRING EARTH (PL6.1.32).
3)
Install the PLATE TIE (PL6.1.35) to the frame using the 4 screws (silver, 6mm).
4)
Secure the harness using the 2 clampers on the PLATE TIE. (Refer to figures.)
When installing, put the HARNESS ASSY TRAY 2 into the notch on the PLATE TIE,
and arrange it as shown in the figure.
5)
Connect the connector (P/J248) of the HARNESS ASSY TRAY 2 (PL6.1.36) to the HARNESS
ASSY CHUTE (PL12.1.17).
6)
Install the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
7)
Install the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
Do not tighten the screw to the left side hole of the CHUTE TRANSFER.
8)
Install the FAN MAIN (PL12.1.10). (RRP12.6)
9)
Install the FUSER ASSY (PL8.1.20). (RRP8.8)
10) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
11) Install the COVER REAR 250 (PL9.1.12). (RRP9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 151