Oki B6200 Maintenance Manual page 364

34PPM
Removal
1) Remove the COVER REAR 500 (PL10.23.21). (RRP10.9)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
5) Remove the COVER EXIT 500 (PL10.1.1). (RRP10.1)
6) Remove the 500 EXIT ASSY (PL10.1.2). (RRP10.2)
7) Remove the COVER TOP (PL1.1.7). (RRP1.4)
8) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
9) Remove the DUCT FRONT (PL8.1.4). (RRP8.2)
10) Remove the 3 screws (silver with flange, 8mm) securing the DUCT HIGH (PL12.1.30), and remove
the DUCT HIGH.
11) Release the 2 clampers holding the harnesses, from the PLATE TIE FRONT (PL12.1.2).
12) Remove the 8 screws (silver, 6mm) securing the PLATE TIE FRONT to the frame, and remove the
PLATE TIE FRONT.
13) Release the 2 clampersholding the harnesses, from the ROS ASSY.
14) Disconnect 4 connectors of the HARNESS ASSY ROS (PL8.1.2).
The printed circuit board on the ROS ASSY is fragile, therefore, be sure to hold it
with hand when disconnecting the connectors.
15) Remove the 4 screws (black with flange, 8mm) securing the ROS ASSY to the frame.
Never give any impact to the ROS ASSY with a screwdriver or other tools.
16) Remove the ROS ASSY.
Replacement
1) Install the ROS ASSY to the frame using the 4 screws (black with flange, 8mm).
Never give any impact to the ROS ASSY with a screwdriver or other tools.
2) Connect the connectors of the HARNESS ASSY ROS to the printed circuit board on the ROS
ASSY.
The printed circuit board on the ROS ASSY is fragile, then, be sure to hold it with
hand when connecting the connectors.
3) Secure the harness with the 2 cable clampers on the ROS ASSY.
4) Install the PLATE TIE FRONT (PL12.1.2) to the frame using the 8 screws (silver, 6mm) and tighten
firmly.
Be sure to perform this operation on a level and smooth worktop.
5) Secure the harness to the PLATE TIE FRONT using the 2 clampers.
6) Secure the DUCT HIGH (PL12.1.30) using the 3 screws (silver with flange, 8mm).
7) Install the DUCT FRONT (PL8.1.4). (RRP8.2)
8) Install the COVER FRONT (PL1.1.5). (RRP1.5)
9) Install the COVER TOP (PL1.1.7). (RRP1.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 200