Oki B6200 Maintenance Manual page 327

Removal
1) Rewmove the EP CARTRIDGE and Paper Cassettes.
2) Remove the COVER REAR 250 (PL9.1.12). (RRP9.4)
3) Remove the COVER REAR (PL1.1.3). (RRP1.1)
4) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
5) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
6) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
7) Remove the CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14). (RRP9.7)
8) Remove the CHUTE LW EXT2 ASSY (PL9.1.2). (RRP9.1)
9) Remove the COVER TOP (PL1.1.7). (RRP1.4)
10) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
11) Place the printer down on its right side.
12) Remove the screw (silver, 6mm) securing the GUIDE TRAY LOWER (PL6.1.10) to the frame.
13) Release the hook of the GUIDE TRAY LOWER from the hole on the frame, and remove the GUIDE
TRAY LOWER.
14) Disconnect the connector (P/J260) of the HARNESS ASSY LOW PAPER SNR from the GUIDE
TRAY RIGHT.
15) Remove the screw (silver, 6mm) securing the GUIDE TRAY RIGHT to the frame.
16) Lift up the hook of the GUIDE TRAY RIGHT, and shift it in the direction of the arrow. Then, remove
the GUIDE TRAY RIGHT from the frame.
Replacement
1) Shift the GUIDE TRAY RIGHT in the opposite direction of the arrow to install it to the frame, and
secure it using the screw (silver, 6mm).
When installing the GUIDE TRAY RIGHT, make sure the installing position of the
PLATE CST LOCK (PL6.1.6) is in the position shown in the figure, NOTE.
2) Connect the connector (P/J260) of the HARNESS ASSY LOW PAPER SNR to the GUIDE TRAY
RIGHT.
3) Put the hook of the GUIDE TRAY LOWER (PL6.1.10) into the hole of the frame, and secure it
using the screw (silver, 6mm).
4) Return the printer to the normal use state.
5) Install the COVER FRONT (PL1.1.5). (RRP1.5)
6) Install the COVER TOP (PL1.1.7). (RRP1.4)
7) Install the CHUTE LW EXT2 ASSY (PL9.1.2). (RRP9.1)
8) Install the CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14). (RRP9.7)
9) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
10) Install the COVER LEFT (PL1.1.6). (RRP1.3)
11) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
12) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
13) Install the COVER REAR 250 (PL9.1.12). (RRP9.4)
14) Install the EP CARTRIDGE and Paper Cassettes.
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 163