Removal
Before performing the following procedures, make sure that the FUSER ASSY was
cooled enough.
1)
Open the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12).
2)
Push down the LEVER FUSER LH (PL8.1.18) and LEVER FUSER RH (PL8.1.19) in the direction
of the arrow to release the lock of the FUSER ASSY.
3)
Shift the FUSER ASSY in the direction of the arrow, and remove it from the printer.
Replacement
1)
Shift the FUSER ASSY in the opposite direction of the arrow, and install it to the printer.
2)
Lock the FUSER ASSY by pulling up the LEVER FUSER LH (PL8.1.18) and LEVER FUSER RH
(PL8.1.19).
3)
Close the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12).
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 238