Oki B6200 Maintenance Manual page 351

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
3) Remove the COVER REAR (PL1.1.3). (RRP1.1)
4) Remove the FAN MAIN (PL12.1.10). (RRP12.6)
5) Remove the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
6) Remove the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
7) Remove the 550 FEEDER ASSY (PL7.1.10). (RRP7.1)
8) Remove the 6 screws (gold tapping, 8mm) securing the PLATE TIE (PL7.1.35) to the CHUTE OUT
(PL7.1.33), and remove the PLATE TIE from the CHUTE OUT.
9) Disconnect the connector (P/J247) of the CLUTCH ASSY PH from the HARNESS ASSY TRAY 2
(PL7.1.36).
10) Remove the E-ring securing the CLUTCH ASSY PH, and remove the CLUTCH ASSY PH from the
SHAFT FEED (PL7.1.26).
Replacement
1) Install the CLUTCH ASSY PH to the SHAFT FEED (PL7.1.26), and secure it using the E-ring.
When installing, make sure that the notch of the CLUTCH ASSY PH is combined
with the boss of the CHUTE OUT.
2) Connect the connector (P/J247) of the CLUTCH ASSY PH to the HARNESS ASSY TRAY 2
(PL7.1.36). After connectiong the connector, put the connector into the space between the ribs of
the CHUTE OUT.
Be careful of the arranging of the harness of the CLUTCH ASSY PH.
3) Install the PLATE TIE (PL7.1.35) to the CHUTE OUT (PL7.1.33) using the 6 screws (gold tapping,
8mm).
4) Install the 550 FEEDER ASSY (PL7.1.10). (RRP7.1)
5) Install the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
6) Install the CHUTE TRANSFER (PL8.1.22). (RRP8.11)
Do not tighten the screw to the left side hole of the CHUTE TRANSFER.
7) Install the FAN MAIN (PL12.1.10). (RRP12.6)
8) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
9) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
10) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 187