Oki B6200 Maintenance Manual page 146

(2) Execute a read verification test again using the "FEED / SELECT" key. The remaining time is
shown. (The execution time in a range between 0 and 255 minutes is indicated in "xxx".)
• When the test has been completed normally, the [Read Verify Test Completed] screen is
shown.
• When the test has been completed abnormally, the [Read Verify Test Completed
abnormally A] screen is shown. (A malfunctioned partition is indicated.)
• If you select "Partition ALL" to instruct the execution, the process is terminated at the
malfunctioned partition and the abnormal termination screen is shown.
If the test has been completed abnormally, make partition size settings ("Partition
setting").
(3) Press the "MENU" key to return to the common menu screen [Diag. Menu Fault Diag.].
6. Show the partition selection screen [Partition A] using the " → " key. You can select the partitions
[Partition A], [Partition B], [Partition C], [PartitionD], [Partition H] and [Partition ALL] in that order,
using the " ↓ " or " ↑ " key.
7. Use the "FEED / SELECT" key to fix the partition for a read verification test. For example, if you
select [Partition D] and fix it, "*" is marked at the right end of the partition name (i,e. [Partition D*]).
8. Show the execution instruction screen [Read Verify Test If OK press SEL] using the "FEED /
SELECT" key.
9. Execute a read verification test again using the "FEED / SELECT" key. The remaining time is
shown. (The execution time in a range between 0 and 255 minutes is indicated in "xxx".)
• When the test has been completed normally, the [Read Verify Test Completed] screen is shown.
• When the test has been completed abnormally, the [Read Verify Test Completed abnormally D]
screen is shown. (A malfunctioned partition is indicated.)
If the test has been completed abnormally, make partition size settings ("Partition
setting").
10. Press the "MENU" key to return to the common menu screen [Diag. Menu Fault Diag.].
<Displaying a partition size>
Procedure:
1. Enter the Diag (C/E) mode, and select [Diag. Menu Fault Diag.] in the same hierarchical level using
the " ↓ " key.
2. Select the [Fault Diag. DC140 Monitor] screen in a lower level using the " → " key.
3. Select [Fault Diag. DC355 HDD DIAG] in the same hierarchical level using the " ↓ " key.
4. Select the [DC355 HDD DIAG Read Verify Test] screen using the " → " key.
5. Select [DC355 HDD DIAG Partition List] in the same hierarchical level using the " ↓ " key.
6. Show the entire HDD size screen using the " → " key.
• The entire HDD size is displayed as a full capacity of HDD, not as a total value of all the partitions.
Partition List
ALL 186
2 - 22
Chapter 2 Operation of Diagnostic