Oki B6200 Maintenance Manual page 470

34PPM
Removal
1) Remove the COVER REAR 500 (PL10.2.21). (RRP10.9)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
4) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
5) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
6) Remove the COVER EXIT 500 (PL10.1.1). (RRP10.1)
7) Remove the 500 EXIT ASST (PL10.1.2). (RRP10.2)
8) Remove the COVER TOP (PL1.1.7). (RRP1.4)
9) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
10) Remove the BTR ASSY (PL8.1.21). (RRP8.10)
11) Remove the GUIDE TRAY LEFT (PL7.1.7). (RRP7.8)
12) Remove the DUCT FRONT (PL8.1.4). (RRP8.2)
13) Remove the ROS ASSY (PL8.1.1). (RRP8.1)
Never give any impact to the ROS ASSY with a screwdriver or other tools.
14) Remove the SHIELD PLATE ROS (PL9.1.3). (RRP8.3)
15) While lifting up the 150 FEEDER ASSY, remove the screw (silver, 6mm) securing the MOTOR
COVER to the frame.
16) Remove the harness connector of MAIN MOTOR.
17) Remove the MOTOR COVER.
Replacement
1) Install the MOTOR COVER to the frame using the screw (silver, 6mm).
2) Install the harness connector of MAIN MOTOR.
3) Install the SHIELD PLATE ROS (PL8.1.3). (RRP8.3)
4) Install the ROS ASSY (PL8.1.1). (RRP8.1)
Never give any impact to the ROS ASSY with a screwdriver or other tools.
5) Install the DUCT FRONT (PL8.1.4). (RRP8.2)
6) Install the GUIDE TRAY LEFT (PL7.1.7). (RRP7.8)
7) Install the COVER FRONT (PL1.1.5). (RRP1.5)
8) Install the COVER TOP (PL1.1.7). (RRP1.4)
9) Install the 500 EXIT ASST (PL10.1.2). (RRP10.2)
10) Install the COVER EXIT 500 (PL10.1.1). (RRP10.1)
11) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
12) Install the COVER LEFT (PL1.1.6). (RRP1.3)
13) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
14) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
15) Install the COVER REAR 500 (PL10.2.21). (RRP10.9)
16) Install the BTR ASSY (PL8.1.21). (RRP8.10)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 306