Oki B6200 Maintenance Manual page 52

Step
5 Is Side Guide tightening the paper too much?
Checking GEAR ASSY HOUSING for rotation
Remove EP CARTRIDGE.
6 Does each gear of GEAR ASSY HOUSING rotate
normally?
Checks by Chapter 2 Diagnostic [Main Motor Test].
Checking paper position
Remove EP CARTRIDGE.
7
Does the front end of paper touch ACTUATOR B of
SENSOR REGI?
Checking ROLL ASSY RETARD
Is ROLL ASSY RETARD clean and installed correctly?
8
Check ROLL ASSY RETARD installed to each Paper
Cassette.
Checking the paper feeding tray
9 Is the paper for test printing supplied from Tray 1 or Tray
2?
Checking CLUTCH ASSY PH for operation
Does CLUTCH ASSY PH operate normally?
10
Checks by Chapter 2 Diagnostic [Tray1/2 Feed Clutch
Test].
Checking CHUTE ASSY FDR1/2 for rotation
Does each gear and roller of CHUTE ASSY FDR1/2 rotate
11
smoothly?
Turn each gear and roller with a finger to check.
Checking the paper feeding tray
12 Is the paper for test printing supplied from Tray 3 or Tray
4?
Checking CLUTCH ASSY PH for operation
Does CLUTCH ASSY PH operate normally?
13
Checks by Chapter 2 Diagnostic [Option Tray1/2 Feed
Clutch Test].
Checking 550 FEEDER OPTION for operation
Does each gear and roller of 550 FEEDER OPTION rotate
14
smoothly?
Turn each gear and roller with a finger to check.
Check
1 - 36
Chapter 1 Troubleshooting
Yes
Slightly widen the
Side Guide, and
run the paper
again.
Check operation
and mounting of
Go to step 7.
HOUSING, and
then go to FIP2.2
MAIN MOTOR.
Go to step 8.
SENSOR REGI.
ASSY RETARD.
Go to step 9.
(RRP2.1, 3.1, 4.1,
With tool
Go to step 10.
Without tool
Go to step 11.
Go to step 12. CLUTCH ASSY
Replace CHUTE
Go to step 12.
ASSY FDR1/2.
With tool
Confirm that the
Go to step 13.
paper is set, and
Without tool
then go to step 9.
Go to step 14.
Go to step 15. CLUTCH ASSY
Go to step 16.
No
Go to step 6.
GEAR ASSY
Go to FIP2.5
Replace ROLL
20.17)
Go to step 12.
Go to FIP2.16
PH.
Go to FIP2.25
PH.
Replace 550
FEEDER
OPTION.
(RRP20.9)