Oki B6200 Maintenance Manual page 347

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
3) Place the printer down on its left side.
Be careful not to scratch the cover, and do not given a shock to the printer from a
top.
4) Open the COVER OPEN (PL1.1.2).
5) While lifting up the boss of the HOLDER LEFT (PL7.1.13) at the back of the 550 FEEDER ASSY,
shift the HOLDER LEFT in the direction of the arrow to remove 3 hooks.
6) Remove the HOLDER LEFT from the SUPPORT NUDGER (PL7.1.12). At the same time, the
ACTUATOR NO PAPER (PL7.1.14) is removed.
7) Release the hook securing the ROLL ASSY NUDGER (PL7.1.19), and pull it out from the SHAFT
NUDGER (PL7.1.17).
When removing, do not hold the rubber rollers of the ROLL ASSY NUDGER.
8) Release the hook securing the GEAR NUDGER, and pull it out from the SHAFT NUDGER.
When removing, do not hold the rubber rollers of the GEAR NUDGER.
Replacement
1) Install the GEAR NUDGER to the SHAFT NUDGER (PL7.1.17), and secure it with the hook.
When installing, do not hold the rubber rollers of the GEAR NUDGER.
Be sure to install the hook of the GEAR NUDGER into the groove of the SHAFT
NUDGER.
2) Install the ROLL ASSY NUDGER (PL7.1.19) to the SHAFT NUDGER, and secure it with the hook.
When installing, do not hold the rubber rollers of the ROLL ASSY NUDGER.
Be sure to install the hook of the ROLL ASSY NUDGER into the groove of the
SHAFT NUDGER.
3) Install the HOLDER LEFT (PL7.1.13) and ACTUATOR NO PAPER (PL7.1.14) to the SUPPORT
NUDGER (PL7.1.12).
Be sure to install the shafts on both ends of the ACTUATOR NO PAPER into the
HOLDER LEFT and SUPPORT NUDGER.
Assemble the hook of the ACTUATOR NO PAPER to the HOLDER LEFT as shown
in the figure.
4) Move the HOLDER LEFT in the opposite direction of the arrow, and secure it to the 550 FEEDER
ASSY with the 3 hooks.
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 183