Oki B6200 Maintenance Manual page 144

9. If you want to terminate the execution of components, use the "CANCEL" key. Then, using the " ↑ "
or " ↓ " key allows you to show the next (previous) component.
10. Pressing the "FEED / SELECT" key allows you to restart the execution of components under
suspension.
11. If you want to switch the cycle operation of an output component, you must go to the list screen.
(1) On the component screen under suspension, use the " → " key to instruct the cycle operation.
(2) When the cycle operation is started, "Cyc" is shown in the status indication on the list screen.
12. If you want to cancel the operation of all the components, you must go to the [DC330 Componets
Cancel All] screen.
(1) On the list screen in progress, use the " ← " key to return to the [DC330 Components Compo-
nent List] screen in an upper hierarchical level.
(2) Select [DC330 Componets Cancel All] in the same hierarchical level using the
" ↓ " key.
(3) Show the [Cancel All If OK press SEL] screen using the " → " key.
(4) Press the "FEED / SELECT" key to cancel the operation and listing of all the components. The
[Cancel All In progress] screen is shown during cancellation.
(5) After the cancellation has been completed, the [Cancel All If OK press SEL] screen is shown
again.
13. Press the "MENU" key to return to the common menu screen [Diag. Menu Fault Diag.].
Component Input
009-002 NG
Component List
009-002 OUT Cyc
2 - 20
Chapter 2 Operation of Diagnostic