Oki B6200 Maintenance Manual page 425

Removal
1) Remove the COVER REAR 250 (PL9.1.12). (RRP9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the CHUTE ASSY EXIT 250 (Reference Only) (PL9.1.14). (RRP9.7)
5) Disconnect the connector (P/J103) of the MOTOR ASSY EXIT (PL9.1.11) from the PWBA EXIT
MOTOR (PL12.1.4).
6) Remove the 5 screws (silver with flange, 8mm ,4 ,silver, 6mm, 1) securing the CHUTE LW EXT2
ASSY to the printer.
7) Remove the CHUTE LW EXT2 ASSY.
Replacement
1) Put the harness of the MOTOR ASSY EXIT (PL9.1.11) assembled into the CHUTE LW EXT2
ASSY into the square hole on the frame.
2) Install the CHUTE LW EXT2 ASSY to the printer.
When installing, pull the CHUTE EXIT FUSER lever.
3) Install the CHUTE LW EXT2 ASSY to the printer using the 5 screws (silver with flange, 8mm, 4, sil-
ver, 6mm, 1).
4) Connect the connector (P/J103) of the MOTOR ASSY EXIT to the PWBA EXIT MOTOR
(PL12.1.4).
5) Install the CHUTE ASSY EXIT 250 (Reference only) (PL9.1.14). (RRP9.7)
6) Install the COVER LEFT (PL1.1.6). (RRP1.3)
7) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
8) Install the COVER REAR 250 (PL9.1.12). (RRP9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 261