Oki B6200 Maintenance Manual page 379

6) Secure the HARNESS ASSY FUSER (PL8.1.17) attached to the GUIDE CRU LEFT to the frame
using harness clamper.
7) Install the connector (P/J4647) of the HARNESS ASSY FUSER to the frame.
8) Install the SHIELD PLATE LVPS (PL12.1.3). (RRP12.1)
9) While lifting up the 150 FEEDER ASSY, install the MOTOR COVER (PL11.1.1). (RRP11.1)
10) Install the SHIELD PLATE ROS (PL8.1.3). (RRP8.3)
11) Install the ROS ASSY (PL8.1.1). (RRP8.1)
Never give any impact to the ROS ASSY with a screwdriver or other tools.
12) Install the DUCT FRONT (PL8.1.4). (RRP8.2)
13) Install the GUIDE TRAY LEFT (PL7.1.7). (RRP7.8)
14) Install the BTR ASSY (PL8.1.21). (RRP8.10)
15) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
16) Install the COVER FRONT (PL1.1.5). (RRP1.5)
17) Install the COVER TOP (PL1.1.7). (RRP1.4)
18) Install the 500 EXIT ASST (PL10.1.2). (RRP10.2)
19) Install the COVER EXIT 500 (PL10.1.1). (RRP10.1)
20) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
21) Install the COVER LEFT (PL1.1.6). (RRP1.3)
22) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
23) Install the COVER REAR 500 (PL10.2.21). (RRP10.9)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 215