Oki B6200 Maintenance Manual page 295

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/PL9.1.12). (RRP10.9/9.4)
2) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
3) Remove the COVER REAR (PL1.1.3). (RRP1.1)
4) Remove the FAN MAIN (PL12.1.10). (RRP12.6)
5) Remove the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
6) Remove the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
7) Remove 2 SPRING REGIs (PL5.1.31) hanging to the CHUTE REGI (PL5.1.25) and ROLL REGI
RUBBER (PL5.1.12) on both sides of the 150 FEEDER ASSY.
8) Remove the E-ring securing the GEAR REGI RUBBER (PL5.1.33) to the ROLL REGI RUBBER,
and remove the GEAR REGI RUBBER from the ROLL REGI RUBBER.
9) Remove the E-ring securing the BEARING REGI LEFT (PL5.1.22) to the ROLL REGI RUBBER.
10) Pull the BEARING REGI LEFT, and turn it in the direction of the arrow shown in the figure, and
remove the notch of the BEARING REGI LEFT from the protrusion of the CHUTE REGI. (NOTE 1)
11) Pull the BEARING REGI LEFT out from the ROLL REGI RUBBER.
12) Remove the E-ring securing the CLUTCH REGI (PL5.1.23), and remove the CLUTCH REGI.
13) Pull the BEARING REGI RIGHT (PL5.1.32), and turn it in the direction of the arrow shown in the
figure, and remove the notch of the BEARING REGI RIGHT from the protrusion of the CHUTE
REGI. (NOTE 1)
14) Pull the BEARING REGI RIGHT out from the ROLL REGI RUBBER.
15) Shift the ROLL REGI RUBBER left, and extract the right of the ROLL REGI RUBBER from the hole
of the CHUTE REGI, and then extract the ROLL REGI RUBBER upward.
When removing, do not hold the rubber rollers of the ROLL REGI RUBBER.
Replacement
1) Shift the ROLL REGI RUBBER in the opposite direction of the arrow, and install it to the 150
FEEDER ASSY.
When installing, do not hold the rubber rollers of the ROLL REGI RUBBER.
Install the ROLL REGI RUBBER so that its D-cut is positioned at the BEARING
REGI RIGHT side.
2) Install the BEARING REGI RIGHT (PL5.1.32) to the ROLL REGI RUBBER.
The shapes of the flange and the positions of the hook are different on the
BEARING REGI RIGHT (white) and BEARING REGI LEFT (black).
3) Turn the BEARING REGI RIGHT in the opposite direction of the arrow, and install it to the CHUTE
REGI.
4) Install the BEARING REGI LEFT (PL5.1.22) to the ROLL REGI RUBBER.
The shapes of the flange and the positions of the hook are different on the
BEARING REGI RIGHT (white) and BEARING REGI LEFT (black).
5) Turn the BEARING REGI LEFT in the opposite direction of the arrow, and install it to the CHUTE
REGI.
6) Clip the E-ring to the ROLL REGI RUBBER to secure the BEARING REGI LEFT.
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 131