Oki B6200 Maintenance Manual page 540

Removal
1) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
2) Remove the SHIELD ASSY ESS (PL12.1.14). (RRP12.8)
3) Remove the SHIELD ASSY WINDOW (PL12.1.15). (RRP12.7)
4) Remove the BRACKET-PWBA HDD (PL12.1.32). (RRP12.11)
5) Remove the screw securing the PANEL REAR (PL12.1.11) to the frame.
6) Remove the PANEL REAR (PL12.1.11).
7) Disconnect the harness connectors from the connectors (P/J30, P/J31, P/J32) of the PWBA ESS
(PL12.1.13).
8) Remove the 7 screws (silver, 6mm) securing the PWBA ESS (PL12.1.13) to the frame.
9) Remove the PWBA ESS (PL12.1.13).
Replacement
1) Install the PWBA ESS (PL12.1.13) to the frame using the 7 screws (silver, 6mm).
When tightening the screws, be careful not to pinch the harness between the
board and frame.
2) Connect the connectors of the harness to the connectors (P/J30, P/L31, P/L32) of the PWBA ESS
(PL12.1.13).
3) Install the PANEL REAR (PL12.1.11) to the frame using the screw.
4) Install the BRACKET-PWBA HDD (PL12.1.32). (RRP12.11)
5) Install the SHIELD ASSY WINDOW (PL12.1.15). (RRP12.7)
6) Install the SHIELD ASSY ESS (PL12.1.14). (RRP12.8)
7) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 376