Oki B6200 Maintenance Manual page 480

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Release the holding of the HARNESS ASSY INTERLOCK2 and HARNESS ASSY LVPS from the
clamps on the GEAR ASSY HOUSING.
5) Remove the 6 screws (silver, 6mm x 5, gold, 6mm x 1) securing the GEAR ASSY HOUSING to the
frame.
6) Release the hooks of the GEAR ASSY HOUSING, and remove it from the frame.
When removing the GEAR ASSY HOUSING, two of the gears that are installed to
the GEAR ASSY HOUSING are not fixed and they may come off. Be careful not to
drop them.
Replacement
1) Install the GEAR ASSY HOUSING to the frame.
When installing, two of the gears that are installed to the GEAR ASSY HOUSING are
not fixed and they may come off. Be careful not to drop them.
When installing, engage the gears of the GEAR ASSY HOUSING, MAIN MOTOR,
and GEAR ASSY PLATE. After assembling, check the engagement of the gears.
The gears will engage easily when they are assembled, by rotating the MAIN
MOTOR with hand.
2) Install the GEAR ASSY HOUSING to the frame using the 6 screws (silver, 6mm x 5, gold, 6mm x
1).
Be sure to tighten the screw (gold, 8mm) shown as "Screw (A)" in the figure.
3)Secure the HARNESS ASSY INTERLOCK2 and HARNESS ASSY LVPS (PL12.1.1)
using the clampers on the GEAR ASSY HOUSING.
4) Install the COVER LEFT (PL1.1.6). (RRP1.3)
5) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
6) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 316