Oki B6200 Maintenance Manual page 184

34PPM
Removal
1) Remove the COVER REAR 500 (PL10.2.21). (RRP10.9)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (PPR1.2)
5) Remove the COVER EXIT 500 (PL10.1.1). (RRP10.1)
6) Remove the 500 EXIT ASSY (PL10.1.2). (RRP10.2)
7) Remove the 2 screws (silver with flange, 8mm) securing the COVER TOP to the printer.
8) Remove the LEVER LINK (PL8.1.29) from the boss of the COVER OPEN (PL1.1.2).
When removing the LEVER LINK from the boss of the COVER OPEN, the COVER
OPEN is opened, and the LEVER LINK is extended.
In the following steps, do not separate the COVER TOP and the printer too far from
the printer, since the OPERATION PANEL (PL1.1.1) attached to the COVER TOP is
connected to the printer.
9) Release the 2 hooks securing the front of the COVER TOP to the COVER FRONT (PL1.1.5), and
pull out the COVER TOP slightly away from the printer.
10) Disconnect the connectors (P/J144 and P/J411) of the SWITCH I/L ASSY from the frame connec-
tors.
11) Disconnect the connector (P/J1) of the OPERATION PANEL.
12) Release the harness clampers of the SWITCH I/L ASSY and OPERATION PANEL.
13) Remove the COVER TOP.
14) Release the 2 hooks securing the OPERATION PANEL to the COVER TOP, and remove the
OPERATION PANEL.
Replacement
1) Install the OPERATION PANEL to the COVER TOP, and secure it using the 2 hooks.
2) Connect the connector (P/J1) of the OPERATION PANEL.
3) Secure the harnesses with the 2 clampers on the SWITCH I/L ASSY and OPERATION PANEL.
4) Connect the connectors (P/J144 and P/J411) of the SWITCH I/L ASSY to the frame connectors.
5) Install the COVER TOP to the printer, and secure it to the COVER FRONT (PL1.1.5) using the 2
hooks at the front of the COVER TOP.
6) Put the boss of the COVER OPEN (PL1.1.2) into the hole of the LEVER LINK (PL8.1.29).
When putting the boss of the COVER OPEN into the hole of the LEVER LINK, the
COVER OPEN should be opened, and the LEVER LINK should be extended.
7) Secure the COVER TOP to the printer using the 2 screws (silver with flange, 8mm).
8) Install the 500 EXIT ASSY (PL10.1.2). (RRP10.2)
When installing, put the harnesses of the MOTOR ASSY EXIT and HARNESS ASSY
EXIT SNR1 into the square hole of the frame.
9) Install the COVER EXIT 500 (PL10.1.1). (RRP10.1)
10) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
11) Install the COVER LEFT (PL1.1.6). (RRP1.3)
12) Install the COVER REAR (PL1.1.3). (RRP1.1)
13) Install the COVER REAR 500 (PL10.2.21). (RRP10.9)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 20