Oki B6200 Maintenance Manual page 441

Removal
1) Remove the COVER REAR 500 (PL10.2.21). (RRP10.9)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
5) Remove the COVER EXIT 500 (PL10.1.1). (RRP10.1)
6) Remove the SHIELD ASSY ESS (PL12.1.14). (RRP12.7)
7) Disconnect the connector (P/J29) of the HARNESS ASSY EXIT SNR from the HVPS/MCU
(PL12.1.19).
8) Disconnect the connector (P/J103) of the MOTOR ASSY EXIT from the PWBA EXIT MOTOR
(PL12.1.4).
9) Remove the 5 screws (gold with spring washer,10mm,x4,silver 6mm,x1)securing the 500 EXIT
ASSY to the printer.
10) Remove the 500 EXIT ASSY.
Replacement
1) Put the harnesses of the MOTOR ASSY EXIT and SENSOR into the hole on the frame.
2) Install the 500 EXIT ASSY using the 5 screws (gold with spring washer,10mm,x4,silver 6mm,x1).
3) Connect the connector (P/J103) of the MOTOR ASSY EXIT to the PWBA EXIT MOTOR
(PL12.1.4).
4) Connect the connector (P/J29) of the HARNESS ASSY EXIT SNR to the HVPS/MCU (PL12.1.19).
5) Install the SHIELD ASSY ESS (PL12.1.14). (RRP12.7)
6) Install the COVER EXIT 500 (PL10.1.1). (RRP10.1)
7) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
8) Install the COVER LEFT (PL1.1.6). (RRP1.3)
9) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
10) Install the COVER REAR 500 (PL10.2.21). (RRP10.9)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 277