Oki B6200 Maintenance Manual page 492

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the COVER REAR (PL1.1.3). (RRP1.1)
3) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
4) Disconnect the harnesses from the connectors (P/J101, P/J102 and P/J103) on the PWBA EXIT
MOTOR.
5) Remove the 2 screws (silver, 6mm) securing the PWBA EXIT MOTOR to the frame.
6) Remove the PWBA EXIT MOTOR.
Replacement
1) Install the PWBA EXIT MOTOR to the frame using the 2 screws (silver, 6mm).
2) Connect the harness connectors to the connectors (P/J101, P/J102 and P/J103) on the PWBA
EXIT MOTOR.
3) Install the COVER LEFT (PL1.1.6). (RRP1.3)
4) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
5) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 328