Removal
1)
Open the COVER OPEN (PL1.1.2) so that the removing operation can be checked visually.
2)
Remove the Paper Cassettes of Tray 1 and Tray 2.
3)
Lift up the 150 FEEDER ASSY (PL5.1.1).
Althrough the 150 FEEDER ASSY clicks into midway when lifted up, push it a little
bit further.
4)
While holding the 150 FEEDER ASSY, release the hook securing the ROLL ASSY NUDGER b y
hand which is inserted from the space left by the Paper Cassettes, and pull it out from the SHAFT
NUDGER (PL6.1.18).
5)
Release the hook securing the ROLL ASSY FEED by using trhe same procedures of step 4 above,
and pull it out from the SHAFT FEED (PL6.1.27).
When removing, do not hold the rubber rollers of the ROLL ASSY NUDGER and
ROLL ASSY FEED.
Replacement
1)
While holding the 150 FEEDER ASSY, install the ROLL ASSY FEED to the SHFT FEED
(PL6.1.27), and secure the ROLL ASSY FEED with the hook by using the same procedures of step
4 of removal.
Be sure to install the hook of the ROLL ASSY FEED into the groove of the SHAFT
FEED.
When installing, do not hold the rubber rollers of the ROLL ASSY NUDGER and
ROLL ASSY FEED.
2)
Install the ROLL ASSY NUDGER to the SHFT NUDGER (PL6.1.18), and secure the ROLL ASSY
NUDGER with the hook.
Be sure to install the hook of the ROLL ASSY NUDGER into the groove of the
SHAFT NUDGER.
3)
Press the 150 FEEDER ASSY (PL5.1.1) down so that it returns to the original position.
4)
Install the Paper Cassettes to the Tray 1 and Tray 2.
5)
Close the COVER OPEN (PL1.1.2).
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 153