Oki B6200 Maintenance Manual page 336

Removal
1) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
2) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
3) Remove the COVER REAR (PL1.1.3). (RRP1.1)
4) Remove the FAN MAIN (PL12.1.10). (RRP12.6)
5) Remove the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
6) Remove the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
7) Disconnect the connector (P/J248) of the HARNESS ASSY TRAY 2 (PL7.1.36) from the HAR-
NESS ASSY CHUTE (PL12.1.17).
8) Release the holdings of the harness from 2 clampers on the PLATE TIE (PL7.1.35).
9) Remove the 4 screws (silver with flange, and spring washer 8mm) securing the PLATE TIE to the
frame.
10) Remove the 2 screws (silver with flange, and spring washer 8mm) securing the CHUTE OUT
(PL7.1.33) to the frame.
11) Remove the 550 FEEDER ASSY from the frame.
Replacement
1) Install the 550 FEEDER ASSY to the frame.
2) Secure the CHUTE OUT (PL7.1.33) to the frame using the 2 screws (silver with flange, and spring
washer 8mm).
One of the screws that secure the CHUTE OUT to the frame is tightened together
with the SPRING EARTH (PL7.1.31).
3) Install the PLATE TIE (PL7.1.35) to the frame using the 4 screws (silver with flange, and spring
washer 8mm).
4) Secure the harness using the 2 clampers on the PLATE TIE. (Refer to figures.)
When installing, put the harness into the notch on the PLATE TIE, and arrange it as
shown in the figure.
5) Connect the connector (P/J248) of the HARNESS ASSY TRAY 2 (PL7.1.36) to the HARNESS
ASSY CHUTE (PL12.1.17).
6) Install the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
7) Install the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
Do not tighten the screw to the left side hole of the CHUTE TRANSFER.
8) Install the FAN MAIN (PL12.1.10). (RRP12.6)
9) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
10) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
11) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 172