Oki B6200 Maintenance Manual page 357

Removal
1) Remove the EP CARTRIDGE and Paper Cassettes.
2) Remove the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
3) Remove the COVER REAR (PL1.1.3). (RRP1.1)
4) Remove the FUSER ASSY (PL8.1.20). (RRP8.8)
5) Remove the COVER LEFT (PL1.1.6). (RRP1.3)
6) Remove the COVER RIGHT (PL1.1.4). (RRP1.2)
7) Remove the COVER EXIT 500/CHUTE ASSY EXIT 250 (Reference Only) (PL10.1.1/9.1.14).
(RRP10.1/9.7)
8) Remove the 500 EXIT ASSY/CHUTE LW EXIT EXT2 ASSY (PL10.1.2/9.1.2). (RRP10.2/9.1)
9) Remove the COVER TOP (PL1.1.7). (RRP1.4)
10) Remove the COVER FRONT (PL1.1.5). (RRP1.5)
11) Place the printer down on its left side.
12) Disconnect the HARNESS ASSY LVPS (PL12.1.1) from the connector (P/J1821) of the GUIDE
TRAY LEFT .
13) Remove the 6 screws (gold tapping, 8mm x 1, gold, 6mm x 5) securing the GUIDE TRAY LEFT to
the frame.
14) Shift the GUIDE TRAY LEFT in the direction of the arrows (A) and (B), and remove it from the
frame.
Replacement
1) Shift the GUIDE TRAY LEFT in the opposite direction of the arrows (A) and (B), and install it to the
frame.
2) Install the GUIDE TRAY LEFT using the 6 screws (gold tapping, 8mm x 1, gold, 6mm x 5).
Be sure to tighten the screw (gold tapping, 8mm) shown as "Screw (A)" in the
figure.
3) Connect the connector (P/J1821) of the GUIDE TRAY LEFT to the HARNESS ASSY LVPS
(PL12.1.1).
4) Return the printer to the normal use state.
5) Install the COVER FRONT (PL1.1.5). (RRP1.5)
6) Install the COVER TOP (PL1.1.7). (RRP1.4)
7) Install the 500 EXIT ASSY/CHUTE LW EXIT EXT2 ASSY (PL10.1.2/9.1.2). (RRP10.2/9.1)
8) Install the COVER EXIT 500/CHUTE ASSY EXIT 250 (Reference Only) (PL10.1.1/9.1.14).
(RRP10.1/9.7)
9) Install the COVER RIGHT (PL1.1.4). (RRP1.2)
10) Install the COVER LEFT (PL1.1.6). (RRP1.3)
11) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
12) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
13) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/9.1.12). (RRP10.9/9.4)
14) Install the EP CARTRIDGE and Paper Cassettes.
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 193