Oki B6200 Maintenance Manual page 296

7) Install the GEAR REGI RUBBER (PL5.1.33) to the ROLL REGI RUBBER, and secure it using the
E-ring.
8) Hang 2 SPRING REGIs (PL5.1.31) to the CHUTE REGI (PL5.1.25) and BEARING REGI RUB-
BER.
When hanging the SPRING REGIs, make sure that the SPRING REGIs are hung to
the boss of the CHUTE REGI, and to the inside of the hooks of the BEARING REGI
LEFT and BEARING REGI RIGHT.
After hanging the SPRING REGIs, make sure the SPRING REGIs have not pinched
the HARNESS ASSY TONER 2. (Refer to NOTE2.)
9) Install the CLUTCH REGI (PL5.1.23). (RRP5.6)
10) Install the 150 FEEDER ASSY (PL5.1.1). (RRP5.1)
11) Install the CHUTE TRANSFER (PL8.1.22) together with the BTR ASSY. (RRP8.11)
Do not tighten the screw to the left side hole of the CHUTE TRANSFER.
12) Install the FAN MAIN (PL12.1.10). (RRP12.6)
13) Install the COVER REAR (PL1.1.3). (RRP1.1)
There are 2 kinds of screws, make sure they are put in the right place.
14) Install the FUSER ASSY (PL8.1.20). (RRP8.8)
15) Install the COVER REAR 500/COVER REAR 250 (PL10.2.21/PL9.1.12). (RRP10.9/9.4)
Chapter 3 Removal and Replacement Procedures (RRPs)
3 – 132